Stepper Motor Driver - 2M2283

Step Motor Driver 2M2283

Step Motor Driver Voltage: 150VAC~220VAC

Stepper Motor Driver Current: 2.0AMPER~8.3AMPER

Stepper Motor Driver Nema: Nema 42, Nema 52

Stepper Motor Driver Phase: 2 Phase

Product Code: Stepper Motor Driver CW2283

You can download the datasheet file by clicking on the product code.

2 Phase Stepper Motor Driver CW2283

• Jumper settings must be made with the drive turned off for safety.
• Ampere settings of the motor will be matched to the RMS setting of the driver.
• Grounding must be done to the metal part of the panel where the drivers are located. Before giving Ampere to the drivers, voltage control must be done by inserting a measuring device between the NEUTRAL and GROUND wires. The ideal situation is zero volts.
• PULSE and DIR signals must be sent as 5V on PLC, Arduino, Axis control card or specially designed cards. For devices with signal output over 5 Volts, a resistance must be entered in the PULSE and DIR signal output cables to be distributed one by one in minus or plus driving. Example The resistance required for 24Volt output is 1.8KΩ.