Stepper Motor with Encoder 12.5 Nm 4.5A

Stepper Motor with Encoder 86BHH114

Stepper Motor with Encoder Maximum Torque: 12.5 NM

Stepper Motor Holding Torque with Encoder: 6.2 NM

Stepper Motor with Encoder Current: 4.5 Amper

Stepper Motor Flange with Encoder: 86X86 mm

Stepper Motor with Encoder Length: 131 mm

Stepper Motor Cable with Encoder: 4 pcs

Stepper Motor with Encoder Product Code: Enkoderli Step Motor 86BHH114-450P-40MP

Torque Curve of Stepper Motor 86BHH114 with Encoder

Encoder Stepper Motor Connection Settings

BLUE: A+

YELLOW: A-

BLACK: B+

RED: B-

Stepper hijacking, which is the most feared stepper motors, has been solved by using closed loop system in these series. The 1000 pulse encoder disk and reader located behind the motor informs the driver whether the motor has taken the required steps or not. The driver strengthens the motor by increasing the amp for the steps it cannot assign. However, if there is a step that it cannot assign, it stops the alarm by lighting. It is preferred that it can respond to sudden stop-starts much faster (closer to the servo) than stepper motors, and the position is guaranteed by following the alarm output.

IMPORTANT REMINDERS
Drive Jumper settings must be made with the drive powered off for safety.
Grounding must be done to the metal part of the panel where the drivers are located. (The need for grounding can be understood by connecting a voltage measuring device to the Neutral and ground wires.)
PULSE and DIR signals must be sent as 5V in PLC, Arduino, Axis control card or specially designed cards.
If the PULSE and DIR signals to be distributed one by one in minus (NPN) or plus (PNP) driving are above 5 volts, a resistance must be entered. Example 1.8KΩ for 24Volt.

Encoder Stepper Motor 86BHH114 Product Video