- $10.00
Stepper Motor Driver - 109S
Step Motor Driver 109S
Stepper Motor Driver Voltage: 9VDC~42VDC
Stepper Motor Driver Current: 0.5AMPER~3.5AMPER
Stepper Motor Driver Nema: Nema 17, Nema 23
Stepper Motor Driver Phase: 2 Phase
Product Code: Stepper Motor Driver 109S
You can download the datasheet file by clicking on the product code.
2 Phase Stepper Motor Driver 109s
- Jumper settings must be made with the drive turned off for safety.
- Ampere settings of the motor will be matched to the RMS setting of the driver.
- Grounding must be done to the metal part of the panel where the drivers are located. Before giving Ampere to the drivers, voltage control must be done by inserting a measuring device between the NEUTRAL and GROUND wires. The ideal situation is zero volts.
- PULSE and DIR signals must be sent as 5V on PLC, Arduino, Axis control card or specially designed cards. For devices with signal output over 5 Volts, a resistance must be entered in the PULSE and DIR signal output cables to be distributed one by one in minus or plus driving. Example The resistance required for 24Volt output is 1.8KΩ.
